Commercial fit-outs
Reconfiguring a salon or spa: compare private rooms with an open station layout
A salon or spa refit can change the balance between private treatment rooms, open workstations and customer-facing space. The removal package should follow that new arrangement, rather than assuming every partition and fitting belongs in one full strip-out.
Siteforce provides commercial strip-outs for agreed ordinary interior removals. Begin with the rooms and stations the next design needs, then identify what the existing premises can retain.
Compare the room arrangement
One project may keep the private rooms and renew their finishes. Another may remove selected partitions to create a more open station area. A third may retain reception while changing the wet-service arrangement at the rear.
For each option, identify partitions, doors, mirrors, attached cabinetry and floor or ceiling areas separately. The construction and role of a partition require assessment; a treatment-room label does not establish that it is an ordinary removable wall.
| Layout choice | Removal interface to resolve |
|---|---|
| Retain private rooms | Finish limits around doors, cabinetry and connected fittings |
| Open selected rooms into a larger area | Wall, ceiling and floor conditions at the former partitions |
| Move basins or wet stations | Responsible-trade preparation and the new installation requirements |
| Keep reception | Retained counter, adjoining surfaces and connections through the work area |
Follow the fixed fittings into the room
Mirrors and cabinets can conceal wall conditions. A counter may contain connections serving equipment or another area. Siteforce’s commercial-counter guide explains why those interfaces need review before attached items are included in removal.
The owner identifies furniture and equipment destinations. Responsible trades and specialists handle their assigned connected-item preparation. Medical-spa procedures and specialist clinical systems are outside the ordinary salon-interior discussion.
Describe the new installer’s starting point
Where rooms open up, the floor and ceiling may need further work at former wall lines. Identify the condition to be left and the contractor responsible for repair or new finishes. Removing partitions is not the same as completing the new open-plan interior.
For wet areas, separate the accepted building removals from new plumbing, waterproofing and fitting installation. The design and responsible trades determine those requirements; the demolition assessment uses the resolved boundaries.
Illustrative example: fewer private rooms, more styling space
This is an illustrative planning example, not a completed Siteforce project.
An incoming operator wants to retain reception and two private rooms while opening another area for styling stations. The design identifies the partitions and attached fittings proposed for removal. A separate wet-station review establishes the preparation and installation requirements at the rear.
The demolition scope then describes the accepted walls, ceiling and floor edges, mirrors and cabinetry. The retained customer-facing area remains visible on the plan. The project team reviews the work route and any proposed continued use against those actual removals.
Bring the room and station plans to Siteforce
Request an assessment with the current and proposed layouts, retained rooms and fit-out contact. Explain the private-room and wet-station decisions still being developed. This gives the removal enquiry a clear intended result.