Commercial fit-outs
Start a retail refurbishment programme with a location-specific removal package
A retail programme can have several locations moving towards the same new design at different stages. One store may have a settled layout, another may still need landlord decisions, and a third may contain substantially different existing fit-out. Choose the first assessment from the actual work available, then develop the next locations on their own conditions.
Siteforce provides commercial strip-outs. A useful programme enquiry identifies real locations, the intended physical result at each and the order being considered. Availability and the accepted work are confirmed against those packages.
Compare the stores before combining the programme
Group the locations by the renovation they need. A finish refresh, selected layout change and wider vacant-unit reset can all belong to one programme while requiring different removal scopes.
| Location type | Information needed for assessment |
|---|---|
| Retained layout with new finishes | Included layers, retained fixtures and receiving-surface requirements |
| New counters or room arrangement | Attached fit-out, partition changes and adjoining finish boundaries |
| Wider interior reset | Defined removals and retained building elements rather than an undefined shell |
The common design helps explain the intended result. It does not establish that hidden assemblies, access arrangements or landlord instructions are identical across the stores.
Choose a first site that can answer useful questions
A well-defined initial location can clarify the removal boundaries and the information needed from later stores. It may reveal an unclear floor endpoint, retained-ceiling interface or connected counter item in the programme documents.
Carry those questions forward. Confirm the answers at each property rather than treating the first store’s conditions as universal. A later location with a different fit-out may need a different package even if its final appearance will be similar.
The retail enquiry drawing guide helps organise one location’s information. Use it as an input to the programme, not as proof that every site is ready for the same work.
Connect each removal to its next trades
Identify the condition the flooring, joinery and other receiving contractors need at each store. The removal programme should account for their actual sequence and shared access requirements.
Siteforce’s follow-on trade guide addresses the narrower work-area interface. Across several locations, also distinguish which site is ready for a defined removal, which needs revised design information and which is awaiting a building decision.
The intended order is useful for planning. It is not a promise of simultaneous crews, fixed turnaround or unrestricted after-hours access at every property.
Illustrative example: a defined first store and two different followers
This is an illustrative planning example, not a completed Siteforce programme.
The first store has a confirmed counter and floor renewal. A second will retain its counter but change back-room partitions. A third is awaiting a landlord decision on retained ceiling areas. The GC develops a scope for each instead of issuing the first store’s removal list to all three.
The initial assessment resolves common questions about receiving finishes. Site-specific decisions remain attached to their actual locations. This gives the programme a practical starting point without hiding the work still needed to define later sites.
Discuss the first locations with Siteforce
Request a programme assessment with the store addresses, intended changes and proposed order. Identify the GC or property contacts and the decisions still open at each location.